Working with MyKolab/da: Difference between revisions

From KDE Wiki Sandbox
(Created page with "== Arbejd med MyKolab ==")
(Created page with "[https://kolab.org Kolab.org] er en Groupware-løsning med fri software, som er nært knyttet til KDE. Denne side beskriver, hvordan man opsætter en [https://mykolab.com MyKo...")
Line 2: Line 2:
== Arbejd med MyKolab ==
== Arbejd med MyKolab ==


[https://kolab.org Kolab.org] is a Free Software Groupware solution closely connected to KDE. This page describes how to set up a [https://mykolab.com MyKolab] account with [[Special:myLanguage/Kontact|Kontact]], but it works with any other Kolab Server as well.
[https://kolab.org Kolab.org] er en Groupware-løsning med fri software, som er nært knyttet til KDE. Denne side beskriver, hvordan man opsætter en [https://mykolab.com MyKolab]-konto i [[Special:myLanguage/Kontact|Kontact]], men det fungerer også med alle andre Kolab-servere.


=== Set up a Kolab Account ===
=== Set up a Kolab Account ===

Revision as of 05:57, 28 October 2013

Other languages:

Arbejd med MyKolab

Kolab.org er en Groupware-løsning med fri software, som er nært knyttet til KDE. Denne side beskriver, hvordan man opsætter en MyKolab-konto i Kontact, men det fungerer også med alle andre Kolab-servere.

Set up a Kolab Account

In order to add a new account to your Kontact, please open the Account Assistant and select Kolab Groupware Server as the account type. Fill out the Personal Settings while making sure that the Server Address is set to imap.mykolab.com and the Kolab Version to v3.

IMAP Configuration

If you followed the above instructions using the Account Assistant, your IMAP account should already have been set up properly. However, you can verify your settings based on the screenshots below. In order to do so, please go to "Settings" in the menu bar and choose Configure Kontact. Then go to KMail and Accounts.

Please make sure that the IMAP Server is imap.mykolab.com and that it uses port 143 with STARTTLS encryption. Please also use your full and primary MyKolab.com address such as user@domain.tld as a username.

SMTP Configuration

Unfortunately, the SMTP settings need to be corrected after account setup. In order to do so, please go to Settings in the menu bar and choose Configure Kontact. Then go to KMail -> Accounts and then click on the Sending tab. The server should be smtp.mykolab.com with port 587 and TLS encryption. Please use your full and primary MyKolab.com address such as user@domain.tld as a username and also see the screenshots below.