Akonadi

From KDE Wiki Sandbox
Revision as of 12:30, 23 November 2008 by 137.226.9.133 (talk) (Add the partially running problem.)

Troubleshooting Tips

  • When reporting problems with the Akonadi server, always include the comprehensive self-test report. This report can be obtained from the self-test dialog which shows up whenever the Akonadi server was unable to start successfully. You also can access this dialog via systemsettings -> Advanced -> Akonadi -> Server Configuration -> Test.
  • Starting the Akonadi server manually on the command line can result in additional useful information. This can be done by running akonadictl start on a console. Similar, with akonadictl stop the Akonadi server can be stopped again.

Common Problems

Apparmor

Some distributions using Apparmor have it set up in a way that prevents Akonadi from running its internal database server. This can result in a variety of fuzzy error messages, including but not limited to the following:

  • unknown error 255 when running akonadictl
  • "DB error: 'Could not open required defaults file: /home/$username/.local/share/akonadi/mysql.conf"

You can solve this by running aa-complain mysqld with root privileges then reload apparmor. On KUbuntu this is:

sudo aa-complain mysqld
sudo /etc/init.d/apparmor reload

Note that you might be using Apparmor even if it does not show up in the process list.

Environment Setup

The Akonadi server searches for Akonadi agents and resources in the paths defined in the XDG_DATA_DIRS environment variable. If Akonadi complains about not finding agents or resources, check if this variable is set correctly. Also keep in mind that even if set in a current console session, it might not have been set when starting the server. Starting the server manually in the current console session excludes this cause.

Restarting after a previous error

If you had problems starting Akonadi and fixed those (such as a missing package or the Apparmor problem) make sure that the Akonadi server is completely shut down before trying to start it again, by calling akonadictl stop on the command line. You can confirm that it was indeed shut down completely by running akonadictl status.

Under some circumstances the Akonadi server can be stuck in a partially running state after a failure which will prevent the next attempt to start it to fail as well. Please file a bug report if you run into this problem including the self-test report of the initial problem.